Back to Assembly Overview

IV-4/IV-17/IV-6 アクリルケース 組み立

These instructions apply to the following enclosure types:

  • IV-4/IV-17
  • IV-6

The cases are identical, except for the top panel.

Step 1

The first step is to peel off the protective tape from all the acrylic pieces.

Once that is done, locate the following pieces:

  • Bottom place (it has four screw holes in it)
  • 2 side plates
  • Front plate (it has air holes on the left side)

Step 2

The pieces will fit together only one way: Rotate the pieces until you find the correct orientation. Start by clipping on the two side plates, then the front plate.

When clipping the pieces together, be sure not to use excessive force as it may damage the acrylic.

Step 3

Now, place the VFD clock so that its legs match up with the screw holes in the bottom plate. Secure the VFD clock to the bottom plate with the four screws included. Be careful against overtightening as it may break the nylon screws.

Step 4

Once the four pieces are put together, locate the back plate and the top plate.

First insert the top plate over the tubes, and then finally the back plate.